Hub/Switch Reference Guide

AP Commands 351

Nortel WLAN—Security Switch 2300 Series Command Line Reference

Usage

Before using this command, you must configure values for the WEP keys you plan to use.

Use the set service-profile wep key-index command.

Examples

The following command configures service profile sp2 to use WEP key 2 for

encrypting multicast traffic:

WSS# set service-profile sp2 wep active-multicast-index 2

success: change accepted.

See Also

• set service-profile wep active-unicast-index on page 341

• set service-profile wep key-index on page 342

• show service-profile on page 380

set service-profile wep active-unicast-index

Specifies the static Wired-Equivalent Privacy (WEP) key (one of four) to use for encrypting unicast frames.

Syntax

set service-profile name wep active-unicast-index num

Defaults

If WEP encryption is enabled and WEP keys are defined, AP radios use WEP key 1 to

encrypt unicast frames, by default.

Access

Enabled.

History

Introduced in WSS Software Version 3.0.

Usage

Before using this command, you must configure values for the WEP keys you plan to use.

Use the set service-profile wep key-index command.

Examples

The following command configures service profile sp2 to use WEP key 4 for

encrypting unicast traffic:

WSS# set service-profile sp2 wep active-unicast-index 4

success: change accepted.