Hub/Switch Reference Guide

346 AP Commands
NN47250-100 (Version 02.51)
See Also show service-profile on page 380
set service-profile user-idle-timeout
Changes the number of seconds WSS Software will leave a session up for a client that is not sending data and
is not responding to keepalives (idle-client probes). If the timer expires, the client’s session is changed to the
Dissociated state.
The timer is reset to 0 each time a client sends data or responds to an idle-client probe. If the idle-client probe
is disabled, the timer is reset each time the client sends data.
Syntax set service-profile name user-idle-timeout seconds
Defaults The default user idle timeout is 180 seconds (3 minutes).
Access Enabled.
History Introduced in WSS Software Version 4.1.
Examples The following command increases the user idle timeout to 360 seconds (6 minutes):
WSS# set service-profile sp1 user-idle-timeout 360
success: change accepted.
See Also
• set service-profile idle-client-probing on page 317
• set service-profile web-portal-logout on page 339
• show service-profile on page 380
set service-profile web-portal-acl
Changes the ACL name WSS Software uses to filter a Web-Portal user’s traffic during authentication.
Use this command if you create a custom Web-Portal ACL to allow more than just DHCP traffic during
authentication. For example, if you configure an ACL that allows a Web-Portal user to access a credit card
server, use this command to use the custom ACL for Web-Portal users that associate with the service profile’s
SSID.
name Service profile name.
seconds Number of seconds a client is allowed to remain idle before
WSS Software changes the session to the Dissociated state. You
can specify from 20 to 86400 seconds.
To disable the timer, specify 0.