Hub/Switch Reference Guide

336 AP Commands
NN47250-100 (Version 02.51)
set service-profile soda agent-directory
Specifies the directory on the WSS where the SODA agent files for a service profile are located.
Syntax set service-profile name soda agent-directory directory
Defaults By default, the WSS expects SODA agent files to be located in a directory with the
same name as the service profile.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Usage If the same SODA agent is used for multiple service profiles, you can use this command to
specify a single directory for SODA agent files on the WSS, rather than placing the same SODA
agent files in a separate directory for each service profile.
Examples The following command specifies soda-agent as the location for SODA agent files for
service profile sp1:
WSS# set service-profile sp1 soda agent-directory soda-agent
success: change accepted.
See Also
• install soda agent on page 542
• uninstall soda agent on page 556
• show service-profile on page 380
set service-profile soda enforce-checks
Specifies whether a client is allowed access to the network after it has downloaded and run the SODA agent
security checks.
Syntax set service-profile name enforce-checks {enable | disable}
Defaults By default, SODA agent checks are performed before the client is allowed access to the
network.
name Service profile name.
directory Directory on the WSS for SODA agent files.
name Service profile name.
enable SODA agent checks are performed before the client is allowed access to
the network.
disable Allows the client access to the network immediately after the SODA
agent is downloaded, without waiting for the checks to be run.