Hub/Switch Reference Guide

AP Commands 335
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults Shared-key authentication is disabled by default.
Access Enabled.
History Introduced in WSS Software Version 3.0.
Usage Shared-key authentication is supported only for encrypted SSIDs. In addition, if you
enable shared-key authentication, RSN, WPA, TKIP, and CCMP must be disabled. By default, RSN,
WPA, and CCMP are already disabled, but TKIP is enabled; you must manually disable TKIP. To
disable TKIP, use the set service-profile cipher-tkip disable command.
Examples The following command enables shared-key authentication in service profile sp4:
WSS# set service-profile sp4 shared-key-auth enable
success: change accepted.
See Also
• set radio-profile mode on page 291
• set service-profile cipher-tkip on page 313
• show service-profile on page 380
set service-profile short-retry-count
Changes the short retry threshold for a service profile. The short retry threshold specifies the number of times
a radio can send a short unicast frame without receiving an acknowledgment. A short unicast frame is a frame
that is shorter than the frag-threshold.
Syntax set service-profile name short-retry-count threshold
Defaults The default short unicast retry threshold is 5 attempts.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Examples The following command changes the short retry threshold for service profile sp1 to 3:
WSS# set service-profile sp1 short-retry-count 3
success: change accepted.
See Also
• set radio-profile frag-threshold on page 289
• set service-profile long-retry-count on page 319
• show service-profile on page 380
name Service profile name.
threshold Number of times a radio can send the same short unicast frame. You can
enter a value from 1 through 15.