Hub/Switch Reference Guide

334 AP Commands
NN47250-100 (Version 02.51)
Syntax set service-profile name rsn-ie {enable | disable}
Defaults The RSN IE is disabled by default.
Access Enabled.
History Introduced in WSS Software Version 3.0.
Usage When the RSN IE is enabled, the default authentication method is 802.1X. There is no
default cipher suite. You must enable the cipher suites you want the radios to support.
Examples The following command enables the RSN IE in service profile sprsn:
WSS# set service-profile sprsn rsn-ie enable
success: change accepted.
See Also
• set service-profile auth-dot1x on page 307
• set service-profile auth-psk on page 309
• set service-profile cipher-ccmp on page 312
• set service-profile cipher-wep104 on page 314
• set service-profile cipher-wep40 on page 315
• show service-profile on page 380
set service-profile shared-key-auth
Enables shared-key authentication, in a service profile.
Syntax set service-profile name shared-key-auth {enable | disable}
name Service profile name.
enable Enables the RSN IE.
disable Disables the RSN IE.
Note. Use this command only if advised to do so by Nortel. This command does not
enable preshared key (PSK) authentication for Wi-Fi Protected Access (WPA). To enable
PSK encryption for WPA, use the set service-profile auth-psk command.
name Service profile name.
enable Enables shared-key authentication.
disable Disables shared-key authentication.