Hub/Switch Reference Guide

328 AP Commands
NN47250-100 (Version 02.51)
Syntax set service-profile name keep-initial-vlan {enable | disable}
Defaults This option is disabled by default.
Access Enabled.
History Introduced in WSS Software Version 5.0.
Usage Even when this option is enabled, the WSS to which a user roams (the roamed-to switch)
can reassign the VLAN in any of the following cases:
• A location policy on the local switch reassigns the VLAN.
• The user is configured in the switch’s local database and the VLAN-Name attribute is set on the user or
on a user group the user is in.
• The access rule on the roamed-to switch uses RADIUS, and the VLAN-Name attribute is set on the
RADIUS server.
Examples The following command enables the keep-initial-vlan option on service profile sp3:
WSS# set service-profile sp3 keep-initial-vlan enable
success: change accepted.
See Also show service-profile on page 380
set service-profile load-balancing-exempt
Exempts a service profile from performing RF load balancing.
Syntax set service-profile name load-balancing-exempt {enable | disable}
Defaults AP radios automatically perform RF load balancing for all service profiles.
Access Enabled.
History Introduced in WSS Version 6.0.
name Service profile name.
enable Enables radios to leave a roamed user on the same VLAN instead of
reassigning the VLAN.
disable Configures radios to reassign a roamed user’s VLAN.
name Service profile name.
enable Exempts the specified service profile from RF load balancing.
disable If a service profile has previously been exempted from RF load balancing,
restores RF load balancing for the service profile.