Hub/Switch Reference Guide

326 AP Commands
NN47250-100 (Version 02.51)
Syntax set service-profile name cos level
Defaults The default static CoS level is 0.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Usage This command applies only when static CoS is enabled. If static CoS is disabled, prioritization is
based on the QoS mode configured in the radio profile, and on any ACLs that set CoS. (See the “Configuring
Quality of Service” chapter of the Nortel WLAN Security Switch 2300 Series Configuration Guide.) To enable
static CoS, use the set service-profile static-cos command.
Examples The following command changes the static CoS level to 7 (voice priority):
WSS# set service-profile sp1 cos 7
success: change accepted.
See Also
• set service-profile static-cos on page 332
• show service-profile on page 380
set service-profile dhcp-restrict
Enables or disables DHCP Restrict on a service profile. DHCP Restrict filters a newly associated client’s traffic to allow
DHCP traffic only, until the client has been authenticated and authorized. All other traffic is captured by the WSS and is
not forwarded. After the client is successfully authorized, the traffic restriction is removed.
Syntax set service-profile name dhcp-restrict {enable | disable}
Defaults DHCP Restrict is disabled by default.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Usage To further reduce the overhead of DHCP traffic, use the set service-profile no-broadcast command
to disable DHCP broadcast traffic from AP radios to clients on the service profile’s SSID.
Examples The following command enables DHCP Restrict on service profile sp1:
WSS# set service-profile sp1 dhcp-restrict enable
success: change accepted.
name Service profile name.
level CoS value assigned by the AP to all traffic in the service profile.
name Service profile name.
enable Enables DHCP Restrict.
disable Disables DHCP Restrict.