Hub/Switch Reference Guide
322 AP Commands
NN47250-100 (Version 02.51)
set service-profile cac-session
Specifies the maximum number of active sessions a radio can have when session-based CAC is enabled. When
an AP radio has reached the maximum allowed number of active sessions, the radio refuses connections from
additional clients.
Syntax
set service-profile name cac-session max-sessions
Defaults
The default number of sessions allowed is 14.
Access
Enabled.
History
Introduced in WSS Software Version 4.1.
Usage
This command applies only when the CAC mode is session. If the CAC mode is none, you
can still change the maximum number of sessions, but the setting does not take effect until you
change the CAC mode to session. To change the CAC mode, use the set service-profile cac-mode
command.
Examples
The following command changes the maximum number of sessions for radios used by
service profile sp1 to 10:
WSS# set service-profile sp1 cac-session 10
success: change accepted.
See Also
• set service-profile cac-mode on page 311
• show service-profile on page 380
set service-profile cipher-ccmp
Enables Counter with Cipher Block Chaining Message Authentication Code Protocol (CCMP) encryption
with WPA clients, for a service profile.
Syntax
set service-profile name cipher-ccmp {enable | disable}
Defaults
CCMP encryption is disabled by default.
Access
Enabled.
History
Introduced in WSS Software Version 3.0.
Usage
To use CCMP, you must also enable the WPA IE.
name Service profile name.
max-sessions Maximum number of active sessions allowed on the radio.
name Service profile name.
enable Enables CCMP encryption for WPA clients.
disable Disables CCMP encryption for WPA clients.