Hub/Switch Reference Guide
320 AP Commands
NN47250-100 (Version 02.51)
set service-profile beacon
Disables or reenables beaconing of the SSID managed by the service profile.
An AP radio responds to an 802.11 probe any request with only the beaconed SSID(s). For a nonbeaconed SSID, radios
respond only to directed 802.11 probe requests that match the nonbeaconed SSID’s SSID string.
When you disable beaconing for an SSID, the radio still sends beacon frames, but the SSID name in the frames is blank.
Syntax
set service-profile name beacon {enable | disable}
Defaults
Beaconing is enabled by default.
Access
Enabled.
History
Introduced in WSS Software Version 3.0.
Examples
The following command disables beaconing of the SSID managed by service profile sp2:
WSS# set service-profile sp2 beacon disable
success: change accepted.
See Also
• set radio-profile beacon-interval on page 285
• set service-profile ssid-name on page 331
• set service-profile ssid-type on page 332
• show service-profile on page 380
set service-profile bridging
Enables wireless bridging for a service profile configured for WLAN mesh services.
Syntax
set service-profile mesh-service-profile bridging
{enable | disable}
Defaults
None.
Access
Enabled.
History
Introduced in WSS Software version 6.0.
name Service profile name.
enable Enables beaconing of the SSID managed by the service profile.
disable Disables beaconing of the SSID managed by the service profile.
mesh-service-profile
Mesh service profile.
Enable Enables wireless bridging for the service profile..
Disable Disables wireless bridging for the service profile.