Hub/Switch Reference Guide

312 AP Commands
NN47250-100 (Version 02.51)
Access Enabled.
History Introduced in WSS Software Version 3.0.
Usage You must configure the service profile before you can map it to a radio profile. You can
map the same service profile to more than one radio profile.
You must disable all radios that use a radio profile before you can change parameters in the profile. Use the set
radio-profile mode command .
web-portal-acl portalacl
Note: This is the default
only if the fallthru type
on the service profile
has been set to web-
portal. Otherwise, the
value is unconfigured.
If set to portalacl and the service
profile fallthru is set to web-
portal, radios use the portalacl
ACL to filter traffic for Web
Portal users during authentication.
If the fallthru type is web-portal
but web-portal-acl is set to an
ACL other than portalacl, the
other ACL is used.
If the fallthru type is not web-
portal, radios do not use the web-
portal-acl setting.
web-portal-form Not configured For Web-based AAA users, serves
the Nortel login page.
web-portal-session-
timeout
5 Allows a Web Portal Web-based
AAA session to remain in the
Deassociated state 5 seconds
before being terminated
automatically.
wep key-index No keys defined Uses dynamic WEP rather than
static WEP.
Note: If you configure a WEP key
for static WEP, WSS Software
continues to also support dynamic
WEP.
wep active-multicast-index 1 Uses WEP key 1 for static WEP
encryption of multicast traffic if
WEP encryption is enabled and
keys are defined.
wep active-unicast-index 1 Uses WEP key 1 for static WEP
encryption of unicast traffic if
WEP encryption is enabled and
keys are defined.
wpa-ie disable Does not use the WPA IE in
transmitted frames.
Table 5: Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When
Parameter Set To
Default Value