Hub/Switch Reference Guide

AP Commands 309
Nortel WLAN—Security Switch 2300 Series Command Line Reference
cipher-ccmp disable Does not use Counter with Cipher
Block Chaining Message
Authentication Code Protocol
(CCMP) to encrypt traffic sent to
WPA clients.
cipher-tkip enable When the WPA IE is enabled,
uses Temporal Key Integrity
Protocol (TKIP) to encrypt traffic
sent to WPA clients.
cipher-wep104 disable Does not use Wired Equivalent
Privacy (WEP) with 104-bit keys
to encrypt traffic sent to WPA
clients.
cipher-wep40 disable Does not use WEP with 40-bit
keys to encrypt traffic sent to
WPA clients.
cos 0 If static CoS is enabled (static-cos
is set to enable), assigns CoS 0 to
all data traffic to or from clients.
dhcp-restrict disable Does not restrict a client’s traffic
to only DHCP traffic while the
client is being authenticated and
authorized.
idle-client-probing enable Sends a keepalive packet (a null-
data frame) to each client every
10 seconds.
keep-initial-vlan disable Reassigns the user to a VLAN
after roaming, instead of leaving
the roamed user on the VLAN
assigned by the switch where the
user logged on.
Note: Enabling this option does
not retain the user’s initial VLAN
assignment in all cases. (For
information, see “set service-
profile keep-initial-vlan” on
page 317.)
long-retry-count 5 Sends a long unicast frame up to
five times without
acknowledgment.
Table 5: Defaults for Service Profile Parameters (continued)
Parameter Default Value
Radio Behavior When
Parameter Set To
Default Value