Hub/Switch Reference Guide

308 AP Commands
NN47250-100 (Version 02.51)
set radio-profile service-profile
Maps a service profile to a radio profile. All radios that use the radio profile also use the parameter settings,
including SSID and encryption settings, in the service profile.
Syntax set radio-profile name service-profile name
Defaults A radio profile does not have a service profile associated with it by default. In this case,
the radios in the radio profile use the default settings for parameters controlled by the service profile.
Table 38 lists the parameters controlled by a service profile and their default values.
radio-profile name Radio profile name of up to 16 alphanumeric characters, with no spaces.
service-profile name Service profile name of up to 16 alphanumeric characters, with no spaces.
Table 5: Defaults for Service Profile Parameters
Parameter Default Value
Radio Behavior When
Parameter Set To
Default Value
attr No attributes configured Does not assign the SSID’s
authorization attribute values to
SSID users, even if attributes are
not otherwise assigned.
auth-dot1x enable When the Wi-Fi Protected Access
(WPA) information element (IE)
is enabled, uses 802.1X to
authenticate WPA clients.
auth-fallthru none Denies access to users who do not
match an 802.1X or MAC
authentication rule for the SSID
requested by the user.
auth-psk disable Does not support using a
preshared key (PSK) to
authenticate WPA clients.
beacon enable Sends beacons to advertise the
SSID managed by the service
profile.
cac-mode none Does not limit the number of
active user sessions based on Call
Admission Control (CAC).
cac-session 14 If session-based CAC is enabled
(cac-mode is set to session),
limits the number of active user
sessions on a radio to 14.