Hub/Switch Reference Guide

AP Commands 307

Nortel WLAN—Security Switch 2300 Series Command Line Reference

Syntax

set radio-profile name rfid-mode {enable | disable}

Defaults

The default is disable.

Access

Enabled.

History

Introduced in WSS Software Version 5.0.

Examples

The following command enables radios managed by radio profile rp1 to act as asset location

receivers:

WSS# set radio-profile rfid-mode enable

success: change accepted.

See Also

• set radio-profile mode on page 291

• show radio-profile on page 376

set radio-profile rts-threshold

Changes the RTS threshold for the AP radios in a radio profile. The RTS threshold specifies the maximum length a

frame can be before the radio uses the RTS/CTS method to send the frame. The RTS/CTS method clears the air of other

traffic to avoid corruption of the frame due to a collision with another frame.

Syntax

set radio-profile name rts-threshold threshold

Defaults

The default RTS threshold for an AP radio is 2346 bytes.

Access

Enabled.

Usage

You must disable all radios that are using a radio profile before you can change parameters in the

profile. Use the set radio-profile mode command

Examples

The following command changes the RTS threshold for radio profile rp1 to 1500 bytes:

WSS# set radio-profile rp1 rts-threshold 1500

success: change accepted.