Hub/Switch Reference Guide

AP Commands 303

Nortel WLAN—Security Switch 2300 Series Command Line Reference

History

Usage

Use the command without any optional parameters to create new profile. If the radio profile does not

already exist, WSS Software creates a new radio profile. Use the enable or disable option to enable or disable

all the radios using a profile. To assign the profile to one or more radios, use the set ap radio radio-profile

command.

To change a parameter in a radio profile, you must first disable all the radios in the profile. After you complete the

change, you can reenable the radios.

To enable or disable specific radios without disabling all of them, use the set ap radio command.

Examples

The following command configures a new radio profile named rp1:

WSS# set radio-profile rp1

success: change accepted.

The following command enables the radios that use radio profile rp1:

WSS# set radio-profile rp1 mode enable

The following commands disable the radios that use radio profile rp1, change the beacon interval, then reenable the

radios:

WSS# set radio-profile rp1 mode disable

WSS# set radio-profile rp1 beacon-interval 200

WSS# set radio-profile rp1 mode enable

The following command enables the WPA IE on AP radios in radio profile rp2:

WSS# set radio-profile rp2 wpa-ie enable

success: change accepted.