Hub/Switch Reference Guide

302 AP Commands
NN47250-100 (Version 02.51)
Access Enabled.
countermeasures Not configured Does not issue countermeasures against
any device.
dtim-interval 1 Sends the delivery traffic indication
map (DTIM) after every beacon.
frag-threshold 2346 Uses the short-retry-count for frames
shorter than 2346 bytes and uses the
long-retry-count for frames that are
2346 bytes or longer.
max-rx-lifetime 2000 Allows a received frame to stay in the
buffer for up to 2000 ms (2 seconds).
max-tx-lifetime 2000 Allows a frame that is scheduled for
transmission to stay in the buffer for up
to 2000 ms (2 seconds).
preamble-length short Advertises support for short 802.11b
preambles, accepts either short or long
802.11b preambles, and generates
unicast frames with the preamble length
specified by the client.
Note: This parameter applies only to
802.11b/g radios.
qos-mode wmm Classifies and marks traffic based on
802.1p and DSCP, and optimizes
forwarding prioritization of AP radios
for Wi-Fi Multimedia (WMM).
rfid-mode disable Radio does not function as a location
receiver in an AeroScout Visibility
System.
rts-threshold 2346 Transmits frames longer than 2346
bytes by means of the Request-to-Send/
Clear-to-Send (RTS/CTS) method.
service-profile No service
profiles defined
You must configure a service profile.
The service profile sets the SSID name
and other parameters.
wmm-powersave disable Requires clients to send a separate
PSpoll to retrieve each unicast packet
buffered by the AP radio.
Table 4: Defaults for Radio Profile Parameters (continued)
Parameter
Default
Value
Radio Behavior When
Parameter Set To Default
Value