Hub/Switch Reference Guide

AP Commands 295
Nortel WLAN—Security Switch 2300 Series Command Line Reference
set radio-profile auto-tune power-ramp-interval
Changes the interval at which power is increased or decreased, in 1 dBm increments, on radios in a radio profile until the
optimum power level calculated by RF Auto-Tuning is reached.
Syntax set radio-profile name auto-tune power-ramp-interval seconds
Defaults The default interval is 60 seconds.
Access Enabled.
History Introduced in WSS Software Version 5.0.
Examples The following command changes the power ramp interval for radios in radio profile rp2 to 120
seconds:
WSS# set radio-profile rp2 auto-tune power-ramp-interval 120
success: change accepted.
See Also
• set ap radio auto-tune max-power on page 265
• set radio-profile auto-tune power-config on page 282
• set radio-profile auto-tune power-interval on page 283
• set radio-profile auto-tune power-lockdown on page 284
• show radio-profile on page 376
set radio-profile beacon-interval
Changes the rate at which each AP radio in a radio profile advertises its service set identifier (SSID).
Syntax set radio-profile name beacon-interval interval
Defaults The beacon interval for AP radios is 100 ms by default.
Access Enabled.
Usage You must disable all radios that are using a radio profile before you can change parameters in the
profile. Use the set radio-profile mode command .
name Radio profile name.
seconds Number of seconds WSS Software waits before increasing or decreasing
radio power by another 1 dBm. You can specify from 1 to 65535.
name Radio profile name.
interval Number of milliseconds (ms) between beacons. You can specify from
25 ms to 8191 ms.