Hub/Switch Reference Guide

294 AP Commands

NN47250-100 (Version 02.51)

History

Introduced in WSS Software Version 3.0.

Examples

The following command sets the power interval for radios in radio profile rp2 to 240

seconds:

WSS# set radio-profile rp2 auto-tune power-interval 240

success: change accepted.

See Also

• set ap radio auto-tune max-power on page 265

• set radio-profile auto-tune power-config on page 282

• set radio-profile auto-tune power-lockdown on page 284

• set radio-profile auto-tune power-ramp-interval on page 285

• show service-profile on page 380

set radio-profile auto-tune power-lockdown

Locks down the current power settings on all radios in a radio profile. The power settings that are in effect

when the command is entered are changed into statically configured power settings on the radios. RF Auto-

Tuning of power is then disabled in the radio profile.

Syntax

set radio-profile name auto-tune power-lockdown

Defaults

By default, when RF Auto-Tuning of power is enabled, power settings continue to be

changed dynamically based on network conditions.

Access

Enabled.

History

Introduced in WSS Software Version 5.0.

Usage

To save this command and the static power configuration commands created when you

enter this command, save the configuration.

Examples

The following command locks down the power settings for radios in radio profile rp2:

WSS# set radio-profile rp2 auto-tune power-lockdown

success: change accepted.