Hub/Switch Reference Guide

AP Commands 293
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Syntax set radio-profile name auto-tune power-config {enable | disable}
Defaults Dynamic power assignment is disabled by default.
Access Enabled.
History Introduced in WSS Software Version 3.0.
Usage When RF Auto-Tuning for power is disabled, WSS Software does not dynamically set the power
levels when radios are first enabled and also does not tune power during operation with associated clients.
When RF Auto-Tuning for power is enabled, WSS Software does not allow you to manually change the power level.
Examples The following command enables dynamic power tuning for radios in the rp2 radio profile:
WSS# set radio-profile rp2 auto-tune power-config enable
success: change accepted.
See Also
• set ap radio auto-tune max-power on page 265
• set radio-profile auto-tune channel-config on page 279
• set radio-profile auto-tune power-interval on page 283
• set radio-profile auto-tune power-lockdown on page 284
• set radio-profile auto-tune power-lockdown on page 284
• show radio-profile on page 376
set radio-profile auto-tune power-interval
Sets the interval at which RF Auto-Tuning decides whether to change the power level on radios in a radio profile. At the
end of each interval, WSS Software processes the results of the RF scans performed during the previous interval, and
changes radio power levels if needed.
Syntax set radio-profile name auto-tune power-interval seconds
Defaults The default power tuning interval is 300 seconds.
Access Enabled.
name Radio profile name.
enable Configures radios to dynamically set their power levels when the APs are
started.
disable Configures radios to use their statically assigned power levels, or the
default power levels if unassigned, when the radios are started.
name Radio profile name.
seconds Number of seconds WSS Software waits before changing radio power
levels to adjust to RF changes, if needed. You can specify from 1 to 65535
seconds.