Hub/Switch Reference Guide

292 AP Commands
NN47250-100 (Version 02.51)
set radio-profile auto-tune channel-lockdown
Locks down the current channel settings on all radios in a radio profile. The channel settings that are in effect
when the command is entered are changed into statically configured channel assignments on the radios. RF
Auto-Tuning of channels is then disabled in the radio profile.
Syntax set radio-profile name auto-tune channel-lockdown
Defaults By default, when RF Auto-Tuning of channels is enabled, channels continue to be
changed dynamically based on network conditions.
Access Enabled.
History Introduced in WSS Software Version 5.0.
Usage To save this command and the static channel configuration commands created when you
enter this command, save the configuration.
Examples The following command locks down the channel settings for radios in radio profile
rp2:
WSS# set radio-profile rp2 auto-tune channel-lockdown
success: change accepted.
See Also
• set radio-profile auto-tune channel-config on page 279
• set radio-profile auto-tune channel-holddown on page 280
• set radio-profile auto-tune channel-interval on page 281
• set radio-profile auto-tune power-lockdown on page 284
• show radio-profile on page 376
set radio-profile auto-tune power-backoff-timer
Deprecated in WSS Software Version 5.0.
set radio-profile auto-tune power-config
Enables or disables dynamic power tuning (RF Auto-Tuning) for the AP radios in a radio profile.
name Radio profile name.