Hub/Switch Reference Guide

AP Commands 291

Nortel WLAN—Security Switch 2300 Series Command Line Reference

• set radio-profile auto-tune channel-interval on page 281

• set radio-profile auto-tune channel-lockdown on page 282

• show radio-profile on page 376

set radio-profile auto-tune channel-interval

Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios in a radio profile.

At the end of each interval, WSS Software processes the results of the RF scans performed during the previous

interval, and changes radio channels if needed.

Syntax

set radio-profile name auto-tune channel-interval seconds

Defaults

The default channel interval is 3600 seconds (one hour).

Access

Enabled.

History

Introduced in WSS Software Version 3.0.

Usage

Nortel recommends that you use an interval of at least 300 seconds (5 minutes).

RF Auto-Tuning can change a radio’s channel before the channel interval expires in response to RF anomalies.

Even in this case, channel changes cannot occur more frequently than the channel holddown interval.

If you set the interval to 0, RF Auto-Tuning does not reevaluate the channel at regular intervals. However,

RF Auto-Tuning can still change the channel in response to RF anomalies.

Examples

The following command sets the channel interval for radios in radio profile rp2 to 2700

seconds (45 minutes):

WSS# set radio-profile rp2 auto-tune channel-interval 2700

success: change accepted.