Hub/Switch Reference Guide

29
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Access Commands
Use access commands to control access to the WLAN Security Switch 2300 Series (WSS Software) (CLI). This chapter
presents access commands alphabetically. Use the following table to locate commands in this chapter based on their use.
disable
Changes the CLI session from enabled mode to restricted access.
Syntax disable
Defaults None.
Access Enabled.
Examples The following command restricts access to the CLI for the current session:
WSS# disable
WSS>
See Also enable on page 19
enable
Places the CLI session in enabled mode, which provides access to all commands required for configuring and moni-
toring the system.
Syntax enable
Access All.
Usage WSS Software displays a password prompt to challenge you with the enable password. To enable a
session, your or another administrator must have configured the enable password to this WSS with the set
enablepass command.
Examples The following command plus the enable password provides enabled access to the CLI for the
current sessions:
WSS> enable
Enter password: password
WSS#
Access Privileges enable on page 19
set enablepass on page 20
disable on page 19
quit on page 20