Hub/Switch Reference Guide
AP Commands 285
Nortel WLAN—Security Switch 2300 Series Command Line Reference
set ap sticky-bit
This command is deprecated in WSS Software Version 4.0. WSS assignment is always sticky. If an AP fails
over to another
WSS connection, the AP stays on that connection until the connection goes down or the WSS
or AP is restarted.
set ap upgrade-firmware
Disables or reenables automatic upgrade of an AP’s boot firmware.
Syntax
set {ap port-list | auto}} upgrade-firmware {enable | disable}
Defaults
Automatic firmware upgrades of AP are enabled by default.
Access
Enabled.
History
Usage
When the feature is enabled on a WSS port, an AP connected to that port upgrades its boot
firmware to the latest version stored on the WSS while booting.
Examples
The following command disables automatic firmware upgrades on the AP connected to
port 9:
WSS# set ap 9 upgrade-firmware disable
See Also
show ap config on page 344
set band-preference
Configures WSS Software to steer clients that support both the 802.11a and 802.11b/g radio bands to a
specific radio on an AP for the purpose of RF load balancing.
ap port-list List of ports connected to the AP(s) on which to allow automatic firmware
upgrades.
ap ap-num Number of a AP on which to allow automatic firmware upgrades.
ap auto Configures firmware upgrades for the AP configuration profile. (See set
ap auto on page 245.)
enable Enables automatic firmware upgrades.
disable Disables automatic firmware upgrades.
Version 4.0 Option auto added for configuration of the AP configuration
profile.
Version 6.0 Option dap removed.