Hub/Switch Reference Guide

AP Commands 283

Nortel WLAN—Security Switch 2300 Series Command Line Reference

Access

Enabled.

Usage

You also can configure a radio’s channel on the same command line. Use the channel

option.

This command is not valid if dynamic power tuning (RF Auto-Tuning) is enabled.

Examples

The following command configures the transmit power on the 802.11a radio on the AP

connected to port 5:

WSS# set ap 5 radio 1 tx-power 10

success: change accepted.

The following command configures the channel and transmit power on the 802.11b/g radio on the AP

connected to port 11:

WSS# set ap 11 radio 1 channel 1 tx-power 10

success: change accepted.