Hub/Switch Reference Guide

AP Commands 281
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Access Enabled.
History
Usage
To enable or disable one or more radios to which a profile is assigned, use the set ap radio radio-
profile command. To enable or disable all radios that use a specific radio profile, use the set radio-profile
command.
Examples The following command enables radio 1 on the AP connected to ports 1 through 5:
WSS# set ap 1-5 radio 1 mode enable
success: change accepted.
The following command enables radio 2 on ports 1 through 3:
WSS# set ap 1-3 radio 2 mode enable
success: change accepted.
See Also
• clear ap image
• set ap radio radio-profile on page 271
• set radio-profile mode on page 291
• show ap config on page 344
set ap radio radio-profile
Assigns a radio profile to an AP radio and enables or disables the radio.
Syntax set {ap port-list | auto}} radio {1 | 2} radio-profile name mode {enable | disable}
Defaults None.
Version 4.0 Option auto added for configuration of the AP configuration
profile.
Version 6.0 Option dap removed.
ap port-list List of ports.
ap ap-num Number of a AP.
ap auto Sets the radio profile for the AP configuration profile. (See set ap auto on
page 245.)
radio 1 Radio 1 of the AP.
radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)
radio-profile name Radio profile name of up to 16 alphanumeric characters, with no spaces.
mode enable Enables radios on the specified ports with the parameter settings in the
specified radio profile.
mode disable Disables radios on the specified ports.