Hub/Switch Reference Guide

AP Commands 279
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Syntax set ap ap-num radio {1 | 2} load-balancing {enable | disable}
Defaults RF load balancing is enabled by default for all AP radios.
Access Enabled.
History Introduced in WSS Software Version 6.0.
Usage By default, RF load balancing is enabled on all AP radios. Use this command to disable or
re-enable RF load balancing for the specified AP radio.
RF load balancing can also be disabled or re-enabled globally with the set load-balancing mode
command. If RF load balancing has been enabled or disabled for a specific AP radio, then the setting
for the individual radio takes precedence over the global setting.
Examples The following command disables RF load balancing for AP radio 1 on AP 7:
WSS# set ap 7 radio 1 load-balancing disable
success: change accepted.
See Also
• set load-balancing strictness on page 277
• clear ap radio load-balancing group on page 241
• set ap local-switching mode on page 260
• show load-balancing group on page 375
set ap radio load-balancing group
Assigns an AP radio to a load balancing group.
Syntax set ap ap-num radio {1 | 2} load-balancing group name [rebalance]
ap ap-number Index value that identifies the AP on the WSS.
radio 1 Radio 1 of the AP.
radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)
enable Enables RF load balancing for the AP radio.
disable Disables RF load balancing for the AP radio.
ap ap-number Index value that identifies the AP on the WSS.
radio 1 Radio 1 of the AP.
radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)