Hub/Switch Reference Guide

278 AP Commands

NN47250-100 (Version 02.51)

set ap radio min-tx-datarate

To specify the minimum rate at which a radio is allowed to transmit traffic to clients, see Deprecated in WSS

Software Version 5.0. on page 266.

set ap radio link-calibration

Configures an AP radio to emit link calibration packets, which can aid in positioning a Mesh AP.

Syntax

set ap ap-number radio {1 | 2} link-calibration mode {enable | disable}

Defaults

Disabled.

Access

Enabled.

History

Introduced in WSS Software Version 6.0.

Usage

A Mesh Portal AP can be configured to emit link calibration packets to assist with

positioning the Mesh AP. A link calibration packet is an unencrypted 802.11 management packet of

type Action. When enabled on an AP, link calibration packets are sent at a rate of 5 per second.

Only one radio on an AP can be configured to send link calibration packets. Link calibration packets

are intended to be used only during installation of APs; they are not intended to be enabled on a

continual basis.

Examples

The following command enables link calibration packets for AP radio 1 on AP 7:

WSS# set ap 7 radio 1 link-calibration mode enable

success : anchor calibration enabled on AP 7 on radio 1.