Hub/Switch Reference Guide

276 AP Commands
NN47250-100 (Version 02.51)
Syntax set {ap port-list | auto}} radio {1 | 2} auto-tune max-power power-level
Defaults The default maximum power setting that RF Auto-Tuning can set on a radio is the highest setting
allowed for the country of operation or highest setting supported on the hardware, whichever is lower.
Access Enabled.
History
Examples
The following command sets the maximum power that RF Auto-Tuning can set on radio 1 on the
AP on port 7 to 12 dBm.
WSS# set ap 7 radio 1 auto-tune max-power 12
success: change accepted.
See Also
• set radio-profile auto-tune power-config on page 282
• set radio-profile auto-tune power-interval on page 283
set ap radio auto-tune max-retransmissions
Deprecated in WSS Software Version 5.0.
set ap radio auto-tune min-client-rate
Deprecated in WSS Software Version 5.0. To configure radio transmit rates, See set service-profile transmit-rates on
page 334.
ap port-list List of ports connected to the AP on which to set the
maximum power.
ap ap-num Number of a AP on which to set the maximum power.
ap auto Sets the maximum power for radios configured by the AP
configuration profile. (See set ap auto on page 245.)
radio 1 Radio 1 of the AP.
radio 2 Radio 2 of the AP. (This option does not apply to single-radio
models.)
power-level Maximum power setting RF Auto-Tuning can assign to the
radio, expressed as the number of decibels in relation to 1
milliwatt (dBm). You can specify a value from 1 up to the
maximum value allowed for the country of operation.
The power-level can be a value from 1 to 20.
Version 4.0 Option auto added for configuration of the AP configuration
profile.
Version 6.0 Option dap removed.