Hub/Switch Reference Guide

AP Commands 275
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Defaults All radios use the internal antenna by default, if the AP model has an internal antenna.
Access Enabled.
History
Usage
This command applies only to the 802.11b/g radio on model 2330.
Examples The following command configures the 802.11b/g radio on AP 1 to use antenna model 24883:
WSS# set ap 1 radio 1 antennatype 24883
success: change accepted.
See Also show ap config on page 344
set ap radio auto-tune max-power
Sets the maximum power that RF Auto-Tuning can set on a radio.
antennatype
{internal | 5303 | mixed | 5133 | 5173 | 5103
| 5133-OUT | 5133-OUT-10 | 5133-OUT-25
| 5133-NEMA | 5133-NEMA-10 | 5133-
NEMA-25 | 5643 | 5643-OUT | 5643-OUT-
10 | 5643-OUT-25 | 5643-NEMA | 5643-
NEMA-10 | 5643-NEMA-25 | 5173-OUT |
5173-OUT-10 | 5173-OUT-25 | 5173-
NEMA | 5173-NEMA-10 |
5173-NEMA-25 | 5103-OUT | 5103-OUT-
10 | 5103-OUT-25 | 5103-NEMA | 5103-
NEMA-10 | 5103-NEMA-25}
802.11a antenna models:
• internal - Omnidirectional puck
• 5303 - Wideband Squint
• 5643 - Omnidirectional Collinear
Dipole
• 5133 - Directional Panel, 60 degrees
• 5173 - Directional Panel, 90 degrees
• 5103 - Directional Panel, 120 degrees
• mixed - Dual-band, Tri-mode 802.11a/
b/g Spatial Diversity Antenna
• -NEMA, -NEMA-10 & -NEMA-25
(Outdoor configurations with base
antenna model)
• -OUT, -OUT-10 & -OUT-25 (Outdoor
configurations with base antenna
model)
Note. The options displayed are dependent upon the access point model number that
this CLI command is executed against.