Hub/Switch Reference Guide

272 AP Commands
NN47250-100 (Version 02.51)
History
Examples
The following command changes the name of the AP on port 1 to techpubs:
WSS# set ap 1 name techpubs
success: change accepted.
See Also show ap config on page 344
set ap radio antenna-location
Specifies the location (indoors or outdoors) of an external antenna. Use this command to ensure that the proper
set of channels is available on the radio. In some cases, the set of valid channels for a radio differs depending
on whether the antenna is located indoors or outdoors.
Syntax set {ap port-list | ap ap-num} antenna-location
{indoors | outdoors}
Defaults The default antenna location is indoor.
Access Enabled.
History Introduced in WSS Software 5.0.
Option dap removed in 6.0.
Examples The following command sets the antenna location for radio 1 on AP 22 to outdoor:
WSS# set ap 22 radio 1 antenna-location outdoor
success: change accepted.
Version 4.1 Default AP name changed from DAPnum to DAPnum
Version 6.0 Option dap removed.
ap port-list List of ports connected to the AP to rename.
ap ap-num Number of a AP to rename.
indoors Specifies that the external antenna is installed indoors (inside the
building).
outdoors Specifies that the external antenna is installed outdoors.