Hub/Switch Reference Guide

AP Commands 269
Nortel WLAN—Security Switch 2300 Series Command Line Reference
History
Usage
You can assign any subset or all of the APs connected to a WSS to a group on that switch. All access
points in a group must be connected to the same WSS.
If you use the name none, spelled in any combination of capital or lowercase letters, the specified AP is cleared
from all AP groups.
Examples The following command configures an AP group named loadbalance1 that contains the APs on
ports 1, 4, and 7:
WSS# set ap 1,4,7 group loadbalance1
success: change accepted.
The following command removes the AP on port 4 from all AP groups:
WSS# set ap 4 group none
success: change accepted.
See Also
• show ap config on page 344
• show ap group on page 357
set ap image
Loads an AirDefense image on an AP.
Syntax set ap ap-number image filename
Defaults None.
Access Enabled.
History
Usage After the AirDefense sensor software is copied to the WSS, use this command to configure an AP to
load the software. When you do this, the software is transferred to the AP, which then reboots and comes up as
an AirDefense sensor.
Version 4.0 Option auto added for configuration of the AP configuration
profile.
Version 6.0 Option dap removed.
ap ap-number Index value that identifies the AP on the WSS.
filename Name of the AirDefense sensor software image file. This file is assumed
to have been copied to the WSS.
Version 5.0 Command introduced.
Version 6.0 Option dap removed.