Hub/Switch Reference Guide

264 AP Commands
NN47250-100 (Version 02.51)
Examples The following command configures AP7 to use a raw PSK to authenticate with a Mesh Portal
AP:
WSS# set ap 7 boot-configuration mesh psk-raw
c25d3fe4483e867d1df96eaacdf8b02451fa0836162e758100f5f6b87965e59d
success: change accepted.
See Also
• set ap boot-configuration mesh ssid on page 254
• set service-profile mesh on page 320
• show ap mesh-links on page 357
set ap boot-configuration mesh ssid
Specifies the name of the SSID a Mesh AP attempts to associate with when it is booted.
Syntax set ap ap-number boot-configuration mesh ssid mesh-ssid
Defaults None.
Access Enabled.
History Introduced in WSS Version 6.0.
Usage You must connect the AP to an WSS and enter this command to specify the mesh SSID prior to
deploying the Mesh AP in its final untethered location. When the AP is booted its untethered location, and it
determines that it has no Ethernet link to the network, it then associates with the specified mesh-ssid.
Examples The following command configures AP 7 to attempt to associate with the SSID WLAN-mesh
when booted in an untethered location:
WSS# set ap 7 boot-configuration mesh ssid wlan-mesh
success: change accepted.
ap ap-number Index value that identifies the AP on the WSS.
mesh-ssid Name of the mesh SSID (up to 32 characters).
Note. When the mesh-ssid is specified, the regulatory domain of the
WSS and the power restrictions are copied to the AP flash memory. This
prevents the Mesh AP from operating outside of regulatory limits after it
is booted and before it receives its complete configuration from the WSS
switch. Consequently, it is important that the regulatory and antenna
information specified on the WSS switch actually reflects the locale
where the Mesh AP is to be deployed, in order to avoid regulatory
violations.