Hub/Switch Reference Guide

258 AP Commands
NN47250-100 (Version 02.51)
Syntax set ap auto persistent [ap-num | all]
Defaults None.
Access Enabled.
History Introduced in WSS Software 4.0.
Option dap removed in 6.0.
Usage To display the AP numbers assigned to Auto-APs, use the show ap status auto command.
Examples The following command converts the configuration of Auto-AP 10 into a permanent
configuration:
WSS# set ap auto persistent 10
success: change accepted.
See Also
• set ap auto on page 245
• set ap auto mode on page 247
• set ap auto radiotype on page 248
set ap auto radiotype
Sets the radio type for single-AP radios that use the AP configuration profile.
Syntax set ap auto [radiotype {11a | 11b| 11g}]
Defaults The default radio type for models 2330, 2330A, 2330B, and 2332 and for the 802.11b/g
radios in other models is 802.11g in regulatory domains that support 802.11g, or 802.11b in
regulatory domains that do not support 802.11g.
Access Enabled.
ap-num Converts the configuration of the AP that has the specified connection
number into a permanent configuration.
all Converts the configurations of all Auto-APs being managed by the switch
into permanent configurations.
radiotype 11a | 11b | 11g Radio type:
• 11a—802.11a
• 11b—802.11b
• 11g—802.11g
Note: