Hub/Switch Reference Guide

AP Commands 257
Nortel WLAN—Security Switch 2300 Series Command Line Reference
• set ap radio auto-tune max-power on page 265
• set ap radio mode on page 270
• set ap radio radio-profile on page 271
• set ap upgrade-firmware on page 275
set ap auto mode
Enables a WSS’s profile for automatic AP configuration.
Syntax set ap auto mode {enable | disable}
Defaults The AP configuration profile is disabled by default.
Access Enabled.
History Introduced in WSS Software 4.0.
Option dap removed in 6.0
Usage You must use the set ap auto command to create the profile before you can enable it.
Examples The following command enables the profile for automatic AP configuration:
WSS# set ap auto mode enable
success: change accepted.
See Also
• set ap auto on page 245
• set ap auto persistent on page 247
• set ap auto radiotype on page 248
• set ap bias on page 249
• set ap blink on page 250
• set ap group on page 258
• set ap radio auto-tune max-power on page 265
• set ap radio mode on page 270
• set ap radio radio-profile on page 271
• set ap upgrade-firmware on page 275
set ap auto persistent
Converts a temporary AP configuration created by the AP configuration profile into a persistent AP configura-
tion on the WSS.
enable Enables the AP configuration profile.
disable Disables the AP configuration profile.