Hub/Switch Reference Guide

256 AP Commands

NN47250-100 (Version 02.51)

Usage

Table 35 lists the configurable profile parameters and their defaults. The only parameter

that requires configuration is the profile mode. The profile is disabled by default. To use the profile

to configure APs, you must enable the profile using the set ap auto mode enable command.

The profile uses the default radio profile by default. You can change the profile using the set ap auto radio

radio-profile command. You can use set ap auto commands to change settings for the parameters listed in

Table 35. (The commands are listed in the “See Also” section.)

Examples

The following command creates a profile for automatic AP configuration:

WSS# set ap auto

success: change accepted.