Hub/Switch Reference Guide

254 AP Commands
NN47250-100 (Version 02.51)
Defaults None.
Access Enabled.
History
Usage If the service profile is mapped to a radio profile, you must remove it from the radio profile
first. (After disabling all radios that use the radio profile, use the clear radio-profile name service-
profile name command.)
Examples The following commands disable the radios that are using radio profile rp6, remove
service-profile svcprof6 from rp6, then clear svcprof6 from the configuration.
WSS# set radio-profile rp6 mode disable
WSS# clear radio-profile rp6 service-profile svcprof6
success: change accepted.
WSS# clear service-profile svcprof6
success: change accepted.
• clear radio-profile on page 242
• set radio-profile mode on page 291
• show service-profile on page 380
soda failure-page Resets the page that is loaded when a client fails the
checks performed by the SODA agent. By default, the
page is generated dynamically.
soda remediation-acl Disables use of the specified remediation ACL for the
service profile. When no remediation ACL is specified, a
client is disconnected form the network when it fails
SODA agent checks.
soda success-page Resets the page that is loaded when a client passes the
checks performed by the SODA agent. By default, the
page is generated dynamically.
soda logout-page Resets the page that is loaded when a client logs out of
the network. By default, the client is disconnected from
the network without a page being loaded.
Version 4.1 Options added to clear SODA parameters.