Hub/Switch Reference Guide

AP Commands 253
Nortel WLAN—Security Switch 2300 Series Command Line Reference
History
Usage If you specify a parameter, the setting for the parameter is reset to its default value. The settings of
the other parameters are unchanged and the radio profile remains in the configuration. If you do not specify a
parameter, the entire radio profile is deleted from the configuration. All radios that use this profile must be
disabled before you can delete the profile.
Examples The following commands disable the radios that are using radio profile rp1 and reset the
beaconed-interval parameter to its default value:
WSS# set radio-profile rp1 mode disable
WSS# clear radio-profile rp1 beacon-interval
success: change accepted.
The following commands disable the radios that are using radio profile rptest and remove the profile:
WSS# set radio-profile rptest mode disable
WSS# clear radio-profile rptest
success: change accepted.
See Also
• set ap radio radio-profile on page 271
• set radio-profile mode on page 291
• show ap config on page 344
• show radio-profile on page 376
clear service-profile
Removes a service profile or resets one of the profile’s parameters to its default value.
Syntax clear service-profile name
[soda {agent-directory | failure-page | remediation-acl | success-page | logout-page}]
Version 4.1 countermeasures parameter added.
Version 5.0 Parameters that no longer apply to radio profiles in WSS
Software Version 4.1 removed:
•long-retry
• short-retry
name Service profile name.
soda agent-directory Resets the directory for Sygate On-Demand (SODA)
agent files to the default directory. By default, the
directory name for SODA agent files is the same as the
service profile name.