Hub/Switch Reference Guide

252 AP Commands
NN47250-100 (Version 02.51)
Examples The following command clears radio 1 on AP 7 from the load balancing group to
which it had been assigned:
WSS# clear ap 7 radio 1 load-balancing group
success : change accepted.
See Also
• set load-balancing strictness on page 277
• set ap radio load-balancing on page 268
• set ap local-switching mode on page 260
• show load-balancing group on page 375
clear radio-profile
Removes a radio profile or resets one of the profile’s parameters to its default value.
Syntax clear radio-profile name [parameter]
Defaults If you reset an individual parameter, the parameter is returned to the default value listed
in Table 37 on page 291.
Access Enabled.
name Radio profile name.
parameter Radio profile parameter:
• beacon-interval
• countermeasures
• dtim-interval
• frag-threshold
• max-rx-lifetime
• max-tx-lifetime
• preamble-length
• rts-threshold
• service-profile
(For information about these parameters, see the set radio-profile
commands that use them.)