Hub/Switch Reference Guide

250 AP Commands
NN47250-100 (Version 02.51)
Access Enabled
History
Usage
When you clear a radio, WSS Software performs the following actions:
• Clears the transmit power, channel, and external antenna setting from the radio.
• Removes the radio from its radio profile and places the radio in the default radio profile.
This command does not affect the PoE setting.
Examples The following command disables and resets radio 2 on the AP connected to port 3:
WSS# clear ap 3 radio 2
See Also
• set ap radio mode on page 270
• set ap radio radio-profile on page 271
• set port type ap on page 41
channel
• 802.11b/g—6
• 802.11a—Lowest valid
channel number for the
country of operation
Number of the channel in which a radio
transmits and receives traffic
mode disable Operational state of the radio.
radio-profile None. You must add the radios to a
radio profile.
802.11 settings
tx-power Highest setting allowed for the
country of operation or highest
setting supported on the hardware,
whichever is lower.
Transmit power of a radio, in decibels referred to
1 milliwatt (dBm)
Version 5.0
• Option antenna-location added.
• Option auto-tune min-client-rate removed.
• Option auto-tune max-retransmissions
removed.
Version 6.0
• Option dap removed for AP.
Table 1: Radio-Specific Parameters (continued)
Parameter Default Value Description