Hub/Switch Reference Guide

AP Commands 249
Nortel WLAN—Security Switch 2300 Series Command Line Reference
• set ap local-switching vlan-profile on page 260
• set vlan-profile
clear ap radio
Disables an AP radio and resets it to its factory default settings.
Syntax clear {ap port-list | ap ap-num} radio {1 | 2 | all}
Defaults The clear ap radio command resets the radio to the default settings listed in Table 34
and in Table 37 on page 291.
ap port-list List of ports connected to the AP(s) on which to reset a radio.
ap ap-num Number of a AP on which to reset a radio.
radio 1 Radio 1 of the AP.
radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)
radio all All radios on the AP.
Table 1: Radio-Specific Parameters
Parameter Default Value Description
antenna-
location
indoor Location of the radio’s antenna.
Note: This parameter applies only to APs that
support external antennas.
Note: Be sure to select the appropriate antenna
configuration that corresponds to indoor or
outdoor operation.
antennatype For most AP models, the default is
internal.
The default for the 802.11b/g radio
on model 2330A is 24883.
Nortel external antenna model
Note: This parameter applies only to APs that
support external antennas.
Note: Be sure to select the appropriate antenna
model for optimum indoor or outdoor operation.
auto-tune max-
power
Highest setting allowed for the
country of operation or highest
setting supported on the hardware,
whichever is lower
Maximum percentage of client retransmissions a
radio can experience before RF Auto-Tuning
considers changing the channel on the radio