Hub/Switch Reference Guide

248 AP Commands
NN47250-100 (Version 02.51)
History
Usage
Use this command to configure an AP that had been converted to an AirDefense sensor to
revert back to an AP. to load the software. When you do this, the next time the AP is booted, it
becomes a Nortel Mobility Point.
Examples The following command causes the AirDefense sensor software file to be cleared from
the configuration of AP 1:
WSS# clear ap 1 image
success: change accepted.
See Also set ap image on page 259
clear ap local-switching vlan-profile
Clears the VLAN profile that had been applied to an AP to use with local switching.
Syntax clear ap ap-number local-switching vlan-profile
Defaults None.
Access Enabled.
History Introduced in WSS Version 6.0.
Usage A VLAN profile consists of a list of VLANs and tags. When a VLAN profile is applied to
an AP, traffic for the VLANs specified in the VLAN profile is locally switched by the AP instead of
being tunneled back to an WSS.
Use this command to reset the VLAN profile used by the AP for local switching to the default
VLAN profile. Traffic that had been locally switched because of an entry in the cleared VLAN
profile is tunneled to an WSS.
When clearing a VLAN profile causes traffic that had been locally switched by APs to be tunneled to
an WSS switch, the sessions of clients associated with the APs where the VLAN profile is applied
are terminated, and the clients must re-associate with the APs.
Examples The following command clears the VLAN profile that had been applied to AP 7:
WSS# clear ap 7 local-switching vlan-profile
success: change accepted.
See Also
• set ap local-switching mode on page 260
Version 5.0 Command introduced.
Version 6.0 Option dap removed.
ap-number Index value that identifies the AP on the WSS switch.