Hub/Switch Reference Guide

243
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands
Use AP commands to configure and manage APs. Be sure to do the following before using the commands:
• Define the country-specific IEEE 802.11 regulations on the WSS. (See set system countrycode on
page 63.)
• Install the AP and connect it to a port on the WSS. (See the Nortel Access Point 2330/2330A/2330B
Installation Guide or Nortel Series 2332 Access Point Installation Guide.)
• Configure an AP access port (for a directly connected AP) or a AP. (See set port type ap on page 41 and
set ap on page 33.)
This chapter presents AP commands alphabetically. Use the following table to locate commands in this
chapter based on their use.
Caution! Changing the system country code after AP configuration disables APs and
deletes their configuration. If you change the country code on a WSS, you must
reconfigure all APs.
Note. For Series 2332 access points, be sure the system country code is supported for
the selected access point model.
Automatic Configuration of
APs
set ap auto on page 245
set ap auto mode on page 247
set ap auto radiotype on page 248
set ap auto persistent on page 247
set ap bias on page 249
set ap blink on page 250
set ap group on page 258
set ap radio auto-tune max-power on page 265
set ap radio auto-tune max-retransmissions on page 266
set ap radio mode on page 270
set ap radio radio-profile on page 271
set ap auto radiotype on page 248
set ap upgrade-firmware on page 275
External Antennas set ap radio antennatype on page 263
set ap radio antenna-location on page 262