Hub/Switch Reference Guide

Network Domain Commands 239

Nortel WLAN—Security Switch 2300 Series Command Line Reference

History

Introduced in WSS Software 4.1.

Usage

This command must be entered on a WSS configured as a Network Domain seed.

Examples

The following command sets the WSS with IP address 192.168.9.254 as a peer of this Network

Domain seed:

WSS# set network-domain peer 192.168.9.254

success: change accepted.

See Also

• clear network-domain on page 225

• show network-domain on page 229

set network-domain mode seed domain-name

Creates a Network Domain by setting the current WSS as a seed device and naming the Network Domain.

Syntax

set network-domain mode seed domain-name net-domain-name

Defaults

None.

Access

Enabled.

History

Introduced in WSS Software 4.1.

Usage

Before you use this command, the current WSS must have its IP address set with the set system ip-

address command. After you enter this command, Network Domain traffic is sent and received from the

specified IP address.

You can configure multiple WSSs as Network Domain seeds. If you do this, you must identify them as peers by using

the set network domain peer command.

Examples

The following command creates a Network Domain named California with the current WSS as a

seed:

WSS# set network-domain mode seed domain-name California

success: change accepted.