Hub/Switch Reference Guide

236 Network Domain Commands
NN47250-100 (Version 02.51)
See Also
• set network-domain mode member seed-ip on page 227
• set network-domain peer on page 228
• set network-domain mode seed domain-name on page 229
clear network-domain mode
Removes the Network Domain seed or member configuration from the WSS.
Syntax clear network-domain mode {seed | member}
Defaults None.
Access Enabled.
History Introduced in WSS Software 4.1.
Usage This command has no effect if the WSS is not configured as part of a Network Domain.
Examples The following command clears the Network Domain member configuration from the
WSS:
23x0# clear network-domain mode member
success: change accepted.
The following command clears the Network Domain seed configuration from the WSS:
23x0# clear network-domain mode seed
success: change accepted.
See Also
• set network-domain mode member seed-ip on page 227
• set network-domain mode seed domain-name on page 229
clear network-domain peer
Removes the configuration of a Network Domain peer from a WSS configured as a Network Domain seed.
Syntax clear network-domain peer {ip-addr | all}
seed Clears the Network Domain seed configuration from the WSS.
member Clears the Network Domain member configuration from the WSS.
ip-addr IP address of the Network Domain peer in dotted decimal notation.
all Clears the Network Domain peer configuration for all peers from the
WSS.