Hub/Switch Reference Guide

Mobility Domain Commands 233
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Syntax show mobility-domain
Defaults None.
Access Enabled.
History Upgraded in WSS Software Version 6.0.
Examples To display Mobility Domain status, type the following command:
WSS# show mobility-domain
Mobility Domain name: Santa Clara
Member State Type (* active) Model Version
--------------- ------------------------- ------------------------- --------------------- ---------------
192.168.253.11 STATE_DOWN Seed Unknown Unknown
192.168.253.12 STATE_UP Secondary seed * 2360 6.0.3.0
Table 32 describes the fields in the display.
See Also
• clear mobility-domain on page 218
• set mobility-domain member on page 219
• set mobility-domain mode member seed-ip on page 220
Table 1: show mobility-domain Output
Field Description
Mobility Domain name Name of the Mobility Domain
Member IP addresses of the seed WSS and members in the Mobility
Domain
State State of the WSS in the Mobility Domain:
• STATE_UP
• STATE_DOWN
Status Role of the WSS in the Mobility Domain:
•MEMBER
• SEED