Hub/Switch Reference Guide

228 Mobility Domain Commands
NN47250-100 (Version 02.51)
clear mobility-domain
Clears all Mobility Domain configuration and information from a WSS, regardless of whether the WSS is a seed or a
member of a Mobility Domain.
Syntax clear mobility-domain
Defaults None.
Access Enabled.
Usage This command has no effect if the WSS is not configured as part of a Mobility Domain.
Examples To clear a Mobility Domain from a WSS within the domain, type the following command:
23x0# clear mobility-domain
success: change accepted.
See Also
• clear mobility-domain member on page 218
• set mobility-domain member on page 219
• set mobility-domain mode member seed-ip on page 220
clear mobility-domain member
On the seed WSS, removes the identified member from the Mobility Domain.
Syntax clear mobility-domain member ip-addr
Defaults None.
Access Enabled.
Usage This command has no effect if the WSS member is not configured as part of a Mobility Domain or
the current WSS is not the seed.
Examples The following command clears a Mobility Domain member with the IP address 192.168.0.1:
23x0# clear mobility-domain member 192.168.0.1
See Also set mobility-domain member on page 219
set domain security
Enables WSS-WSS security in the WSS’s Mobility Domain.
ip-addr IP address of the Mobility Domain member, in dotted decimal notation.