Hub/Switch Reference Guide

227
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Mobility Domain Commands
Use Mobility Domain commands to configure and manage Mobility Domain groups.
A Mobility Domain is a system of WSSs and APs working together to support a roaming user (client). One WSS acts as
a seed switch, which maintains and distributes a list of IP addresses of the domain members.
This chapter presents Mobility Domain commands alphabetically. Use the following table to locate commands in this
chapter based on their use.
clear domain security
Disables WSS-WSS security.
Syntax clear domain security
Defaults None.
Access Enabled.
History Introduced in WSS Software 5.0.
Usage This command is equivalent to the set domain security none command.
Examples The following command disables WSS-WSS security on a WSS:
23x0# clear domain security
success: change accepted.
Note. Nortel recommends that you run the same WSS Software version on all the WSSs
in a Mobility Domain.
Mobility Domain set mobility-domain mode secondary-seed domain-name seed-ip on
page 222
set domain security on page 218
set mobility-domain member on page 219
set mobility-domain mode member seed-ip on page 220
set mobility-domain mode member secondary-seed-ip on page 220
show mobility-domain on page 222
show mobility-domain config on page 222
clear mobility-domain member on page 218
clear domain security on page 217
clear mobility-domain on page 218