Hub/Switch Reference Guide

212 AAA Commands
NN47250-100 (Version 02.51)
Examples The following command assigns input access control list (ACL) acl-03 to filter the
packets from a user at MAC address 01:02:03:04:05:06:
WSS# set mac-user 01:02:03:04:05:06 attr filter-id acl-03.in
success: change accepted.
url
(network access mode
only)
URL to which the user is
redirected after successful
Web-based AAA.
Web URL, in standard format. For example:
http://www.example.com
Note: You must include the http:// portion.
You can dynamically include any of the variables
in the URL string:
• $u—Username
• $v—VLAN
• $s—SSID
• $p—Service profile name
To use the literal character $ or ?, use the
following:
•$$
•$q
vlan-name
(network access mode
only)
Virtual LAN (VLAN)
assignment.
Note: VLAN-Name is a
Nortel vendor-specific
attribute (VSA). The
vendor ID is 562, and the
vendor type is 231.
Note: On some RADIUS
servers, you might need to
use the standard RADIUS
attribute Tunnel-Pvt-
Group-ID, instead of
VLAN-Name.
Name of a VLAN that you want the user to use.
The VLAN must be configured on a WSS within
the Mobility Domain to which this WSS belongs.
acct-interim-interval Interval in seconds between
accounting updates, if start-
stop accounting mode is
enabled.
Number between 180 and 3,600 seconds, or 0 to
disable periodic accounting updates.
The WSS ignores the acct-interim-interval value
and issues a log message if the value is below 60
seconds.
Note: If both a RADIUS server and the WSS
supply a value for the acct-interim-interval
attribute, then the value from the WSS takes
precedence.
Table 1: Authentication Attributes for Local Users (continued)
Attribute Description Valid Value(s)