Hub/Switch Reference Guide

AAA Commands 209
Nortel WLAN—Security Switch 2300 Series Command Line Reference
filter-id
(network access mode
only)
Security access control list
(ACL), to permit or deny
traffic received (input) or
sent (output) by the WSS.
(For more information
about security ACLs, see
“Security ACL
Commands” on page 449.)
Name of an existing security ACL, up to
253 alphanumeric characters, with no tabs or
spaces.
• Use acl-name.in to filter traffic that
enters the switch from users via an
AP access port or wired
authentication port, or from the
network via a network port.
• Use acl-name.out to filter traffic sent
from the switch to users via an AP
access port or wired authentication
port, or from the network via a
network port.
Note: If the Filter-Id value returned through the
authentication and authorization process does not
match the name of a committed security ACL in
the WSS, the user fails authorization and is
unable to authenticate.
idle-timeout This option is not implemented in the current WSS Software version.
mobility-profile
(network access mode
only)
Mobility Profile attribute
for the user. (For more
information, see set
mobility-profile on
page 204.)
Note: Mobility-Profile is a
Nortel vendor-specific
attribute (VSA). The
vendor ID is 562, and the
vendor type is 232.
Name of an existing Mobility Profile, which can
be up to 32 alphanumeric characters, with no tabs
or spaces.
Note: If the Mobility Profile feature is enabled,
and a user is assigned the name of a Mobility
Profile that does not exist on the WSS, the user is
denied access.
Table 1: Authentication Attributes for Local Users (continued)
Attribute Description Valid Value(s)