Hub/Switch Reference Guide

IP Services Commands 167
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also
• clear ntp server on page 102
• clear summertime on page 105
• clear timezone on page 106
• set ntp on page 121
Table 11: Output for show ntp
Field Description
NTP client State of the NTP client. The state can be one of the following:
• Enabled
• Disabled
Current update-interval Number of seconds between queries sent by the WSS to the NTP
servers for updates.
Current time System time that was current on the WSS when you pressed
Enter after typing the show ntp command.
Timezone Time zone configured on the switch. WSS Software offsets the
time reported by the NTP server based on the time zone.
Note: This field is displayed only if you change the time zone.
Summertime Summertime period configured on the switch. WSS Software
offsets the system time +1 hour and returns it to standard time for
daylight savings time or a similar summertime period that you
set.
Note: This field is displayed only if you enable summertime.
Last NTP update Time when the switch received the most recent update from an
NTP server.
NTP Server IP address of the NTP server.
Peer state State of the NTP session from the point of view of the NTP
server:
• CORRECT
•REJECT
• SELCAND
• SYNCCAND
• SYSPEER
Local state State of the NTP session from the point of view of the WSS’s
NTP client:
•INITED
•START
•SYNCED