Hub/Switch Reference Guide

IP Services Commands 165
Nortel WLAN—Security Switch 2300 Series Command Line Reference
See Also
• clear ip route on page 101
• set interface on page 109
• set ip route on page 116
• show interface on page 149
• show vlan config on page 89
show ip telnet
Displays information about the Telnet management port.
Syntax show ip telnet
Defaults None.
Access All.
Examples The following command shows the status and port number for the Telnet management
interface to the WSS:
WSS> show ip telnet
Server Status Port
----------------------------------
Enabled 23
Table 26 describes the fields in this display.
Gateway Next-hop router for reaching the route destination.
Note: This field applies only to static routes.
VLAN:Interface Destination VLAN, protocol type, and IP address of the route.
Because direct routes are for local interfaces, a destination IP
address is not listed.
The destination for the IP multicast route is MULTICAST.
For static routes, the value Down means the WSS does not have
an interface to the destination’s next-hop router. To provide an
interface, configure an IP interface that is in the same IP subnet
as the next-hop router. The IP interface must be on a VLAN
containing the port that is attached to the default router.
Table 9: Output for show ip route (continued)
Field Description